SCANTECH ID (Champtek company) SG20 - Manual (Page 7)

Interface Manual Scantech SG-20 Discovery WLAN Rel 1.1 5
1.6 Own IP Address: The IP Address the Discovery will use.
Enter 0.0.1.0 to obtain an address through DHCP.
1.7 Own Port: The Port number to communicate on
1.8 Remote IP Address: the IP Address the Discovery tries
to connect to (in case of TCP Client) or is sending its
data to (in case of UDP (see also 1.12).
1.9 Remote Port: The remote port.
1.10 Subnet Mask: Enter The Subnet mask
1.11 Gateway: The gateway to communicate
through. Enter 0.0.0.0 if not used
1.12 Connect Mode, there are 3 options:
- TCP Client: The Discovery tries to connect to the
remote IP Address + Port, using TCP
- TCP Server: The Discovery waits for a client to
connect, using TCP
- UDP: uses the connectionless datagram protocol
1.13 Other settings: The Ethernet module has many
more settings than the ones above. This option
determines what to do with those, when saving the
above settings
Leave unmodified: When saving the above
settings, all other settings are left unmodified.
To be used if customer-specific Ethernet settings
are used
Discovery defaults: When saving the above
settings, all other settings are returned to
Scantech factory defaults.
1.14 Interface Mode: The physical interface the WLAN
module uses. You can choose from:
- WLAN: 802.11b/g Wireless LAN
- LAN: 10/100Mbit wired Ethernet