Procom DFSA-4-tetra-bz-bbmu1 User Manual
Page 2
INSTALLATION
This antenna is supplied with type BZ-mount. The whip is fastened to the
mount by means of our standard ball-joint and wing screw system. The
adjustable ball-joint ensures that the whip can always be mounted in a
vertical position independent of the angle of the installation spot.
The BZ-mount is particularly well suited for mounting on car roofs because
of its ability to be installed exclusively with access from the outside. The BZ-
mount for roof thicknesses from 2 mm to
7.5 mm must be mounted from the inside. However, the antenna can be
installed anywhere on the car as the BZ-mount is equally well suited for
mounting on e.g. trunk or wing
1. INSTALLATION DIMENSIONS
2. INSTALLATION STEPS
Do not use sealer on rubber gasket or other places.
PLEASE NOTE
As standard the antenna is provided with wing screw. However, the wing
screw may be replaced by the less obtrusive hat screw (with key), which
also gives an improved protection against theft. To order the antenna with
hat screw, please add a “K” to the antenna designation.
PROCOM A/S reserve the right to amend specifications
without prior notice.
06/02/12