Procom MU 1-x-... - Manual (Page 2)

INSTALLATION
This antenna should always be mounted on the car roof to ensure best
omnidirectional coverage.
Mounting can take place exclusively with access from the outside when
drilling an 18 mm dia. hole. Mounting can take place from the inside by
drilling a 14 mm dia. hole. When mounting in a 14 mm dia. hole, remove the
bottom plastic ring of the packing gasket with a sharp cutter.
When cleaning the car in car-washing machines, remove the whip using a
spanner, size 9 mm. After wash, refit the whip and tighten it lightly with the
spanner.
The MiniMag (abbreviated: MM) is a small, light-weight magnetic mount with
a high attaching effect. A silicone layer applied to the contact surface
protects the car roof and ensures maximum friction.
1. INSTALLATION DIMENSIONS
2. INSTALLATION STEPS
Do not use sealer on rubber gasket or other places.
3. TUNING/MODEL CONVERSION
The antenna is delivered factory-tuned and requires no further tuning.
To convert an MU 1-X/s model into an MU 1-X/l model, cut off 15 mm of
the top end of the whip.
To convert an MU 1-X/l model into an MU 1-X/h model, cut off 11 mm of
the top end of the whip.
PLEASE NOTE
For safety reasons: When using the MU 1-MM, car speed must not exceed
140 km/h.
PROCOM A/S reserve the right to amend specifications
without prior notice.
02/12/11