Universal Audio DCS-RP Manual - Manual (Page 6)

1
DCS Remote Preamp Performance Specifications
A Mic, B Mic input type: XLR balanced, transformer-less
input impedance: 2 k ohms
peak input level: +14dBu RMS sine wave
CMR: >70dB 20Hz to 20kHz
A DI, B DI
input type: TRS balanced or TS unbalanced, transformer-less
input impedance: 4 M ohms balanced, 2 M ohms unbalanced
peak input level: +24dBu RMS sine wave
CMR: >60dB 20Hz to 1kHz, >45dB 1kHz to 20kHz
Pre Outputs
output type: TRS balanced or TS unbalanced, transformer-less
peak output level: +24dBu balanced, +18dBu unbalanced, RMS sine wave
(adjustable from 0dBu to +24dBu using GAIN Trim
control)
output impedance: 200 ohms balanced, 100 ohms unbalanced
A B Stereo Out
output type: TRS stereo, unbalanced, *mono-summable by shorting T-S
peak output level: +6dBu/+4dBV RMS sine wave (-10dBV operating level)
output impedance: 500 ohms
throughput
frequency response: 4Hz to 150kHz, +0/-3dB
Mic input noise: -130dBu EIN, 50 ohms 20Hz to 20kHz, 69 dB gain
DI input noise: -100dBu EIN, 50 ohms 20Hz to 20kHz, 42 dB gain
distortion (THD+N): 0.002%, 1kHz, 40dB gain, +14dBu out
cross-talk: -100dB any Mic, DI, Cue Mixer input to Preamp out
Audio Specifications: Cue Mixer
C IN
input type: TRS x 2, balanced or unbalanced, mono on left
peak input level: H: +24dBu, L: +12dBu RMS sine wave (see CFG, pg 7)
input impedance: 20 k ohms
CUE IN
input type: TRS stereo, unbalanced
peak input level: +24dBu RMS sine wave
input impedance: 20 k ohms
CUE OUT
output type: TRS stereo, unbalanced, *mono-summable by shorting T-S
peak output level: +18dBu sine wave (190mW/channel into 50 ohms)
output impedance: 50 ohms
drive capability: 2 sets of 25-600 ohm phones (best if both pairs matched)
SPKR OUT
output type: TRS x 2, balanced or unbalanced, *mono on left
peak output level: H: +18dBu, L: +6dBu RMS sine wave (see CFG, pg 7)
output impedance: 1k ohms balanced, 500 ohms unbalanced
TALK MIC OUT
output type: TRS balanced or unbalanced
peak output level: +6dBu/+4dBV RMS sine wave (-10dBV operating level)
output impedance: 250 ohms balanced, 125 ohms unbalanced
throughput
frequency response: 8Hz to 60kHz, +0/-3dB, any input to SPKR OUT
noise: L: -86dBu, H: -76dBu, 20Hz - 20kHz, SPKR OUT, CUE VOL full CW
distortion (THD+N): 0.004%, 1kHz, +14dBu output, 20Hz to 20kHz
cross-talk: -100dB any mic, DI, CUE MIXER in to CUE MIXER out
REVERB
sample rate/bit depth: 48 kHz/20-bit
power usage 17 Watts, fixed voltage