SENA Parani-SD200L - Manual (Page 15)

15
SD2, respectively.
Step 1. Turn off all the nearby Parani-SD’s
Step 2. Turn on SD1 and SD2 and hardware reset both of them by pressing Reset Button.
Step 3. Press the Pairing Button of SD1 for 2 seconds until Standby LED turns off and Connect LED
blinks 3 times every 2 seconds. Keep the power ON.
Step 4. Press the Pairing Button of SD2 for 2 seconds until Standby LED turns off and Connect LED
blinks 3 times every 2 seconds. Now press again the Pairing Button for 2 seconds until Connect
LED blinks every 0.5 second.
Step 5. Wait for SD1 & SD2 to connect to each other until the Connect LED’s of SD1 and SD2 are fully
solid green. It takes about 10 seconds to make a connection. If there are many Bluetooth devices
nearby, it may take longer.
Step 6. Turn SD1 off and on. Connect LED blinks twice in green every 3 seconds.
Step 7. Turn SD2 off and on. Connect LED blinks once in green every 1 second.
Step 8. Now SD1 and SD2 are configured to make automatic connection to each other, whenever they
are powered on.
Using a pair of Parani -SD200L in this fashion is similar to that of using a wireless serial cable.
* Note: When using the pairing buttons, the Command Response option will be deactivated
automatically. The Parani -SD200L will not send the response messages such as OK, Connect and
Disconnect.
Table 3-6 Pairing Process by Pairing Button
SD1 Status LED SD2 Status LED
1. Hard reset Mode0 Standby LED blinks 2
times every 1 seconds 1. Hard reset Mode0 Standby LED blinks 2
times every 1 seconds
2. Push pairing
button Mode3 Connect LED blinks 3
times every 2 seconds 2. Push pairing
button Mode3 Connect LED blinks 2
times every 2 seconds
3. Push pairing
button again Mode1 Connect LED blinks
every 0.5 seconds
4. Connected Slave Connect LED is lit in
green 4. Connected Master Connect LED is lit in
green
3.9 Software and Utility
This configuration software and utility for firmware update is included with the product, which also can
be downloaded from http://www.sena.com
Table 3-7 Configuration Software
Software Purpose Operating System
ParaniWIN Configuration MS Windows 98SE or Higher
ParaniUpdater Firmware Update MS Windows 98SE or Higher
3.10 ParaniWIN
ParaniWIN is a program that runs on Microsoft Windows for the configuration of Parani -SD200L.
Install ParaniWIN on your computer. Plug a Parani-SD200L into the serial port of the computer and
turn on the power. Run ParaniWIN.