Pfister F-049-SYKK - Manual (Page 3)

ENGLISH
ENGLISH
6 7
6 VALVE BODY INSTALLATION
Before proceeding, Valve Stems ( 6A) are to be set in the closed position. From
underneath sink, place Large Square Washer (6B) and Sleeve (6C) onto Valve Shank
(6D). Place Small Square Washer (6E) and tighten loosely with Mounting Nut (6F).
Temporarily place Handle (6G) onto Valve Stem (6A) to make sure the handle levers
are properly aligned to sink. Remove Handle (6G) and tighten Mounting Nut (6F) until
Valve Body (6H) is firmly secured to sink.
Do not use Handles ( 6G) to tighten or to rotate Valve Bodies (6H)!
7 HANDLE ATTACHMENT
Place Plastic Seal Rings (7A) against the bottom of Handle Hubs (7B). Connect Handles
(7C) onto Valve Adapters (7D).
Be sure Valves and Levers are in the “OFF” position. Secure handles by holding the
Lever (7E) in place and tighten the Hubs (7B) by rotating them in a clockwise direction.
To remove handles, rotate Hubs (7B) in a counterclockwise direction.
3
6A
6G
6G
6B
6B
6C
6C
6D
6D
6E
6E
6F
6F
6A
7A
7B
7D
7D
7E
7B
7B
7A
6H
6H
6C
6C