Pfister F-049-VTKK - Manual (Page 4)

ENGLISH
ENGLISH
13
10
11
12
10 HOSE CONNECTION
From underneath sink, push the Center Connector (10A) onto receiving Tube (10B),
until unable to push any further. Pull down on the quick connect housing (10A). If the
housing and the Inner Collet (10C) separate slightly but do not pull off receiving Tube
(10B), the connection is secure.
Slide the End Connectors (10D) with arrow (10E) pointing up onto the Valve Bodies
(10F). Push the End Connectors (10D) all the way up until completely seated. Be
careful not to damage O-Rings (10G).
11 POP-UP INSTALLATION
Install and adjust Pop-Up (11A) using separate instructions supplied with the Pop-Up
assembly.
12 WATER SUPPLY CONNECTIONS
First, thread Inlet Connectors (12A) into Water Supply Lines (12B). Then, insert Inlet
Connectors (12A) into Valve Bodies (12C).
Hot water supply lines go into left inlet.
Cold water supply lines go into right inlet. (Supply lines not included). Please follow
manufacturer’s instructions when installing supply lines. Next, insert Clips (12D) into
Valve Body Holes (12E), to secure unit.
WARNING: Do not twist Inlet Connectors (12A) once installed!
13 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
4
HOT
COLD
10A
10D
10D
10F
10G
10F
10G
10D
10E
10A
10B
10C
10B
10A
12A
12A
12D
12B
12C
12C
12D
12B
12E
12D
10C
10B
10B
11A