Sample copy, En g li sh – Factory Direct Hardware Pfister GT40-N00 User Manual

Page 2

ENGLISH

Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to

provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow

illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).

1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before proceeding. Price Pfister

recommends calling a professional if you are uncertain about installing this product!

This product should be installed in accordance with all local and state plumbing and

building codes.

2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply valves. These are usually found

under the sink or near the water meter. If you are replacing an existing faucet, remove

the old faucet from the sink and clean the sink surface thoroughly.

3 TOOLS RECOMMENDED

• Plumber's putty

• Slotted screwdriver

• Pliers

• Adjustable wrench

• Flashlight

• Cloth

Your installation may require new supply lines and / or shut-off valves or other additional

tools.

4 FAUCET INSTALLATION

Following manufacturer’s recommendations on use, apply plumber’s putty into putty

groove in bottom of Putty Plate (4A). With the handle and spout facing forward, carefully

insert Threaded Shank (4B) and Faucet Inlets (4C) through hole on sink.

5 SECURING FAUCET

From underneath sink, secure Faucet Body (5A) by placing Metal Washer (5B) and

threading Long Nut (

“ Hex.) (5C) onto Threaded Shank (5D). Make sure that the

bumps on Metal Washer (5B) are facing up. Firmly hand tighten Long Nut (5C). Secure

Long Nut (5C) not to exceed a quarter turn.

Caution: Do not over tighten!

The Red and Blue Indicator (5E) can be switch with a solid colored Indicator (5F)

that is provided (See step 11).

BOTTOM GROOVE

sample

copy