Factory Direct Hardware Houzer CTG-3200 - Manual (Page 3)

6. Loosely attach mounting brackets to the countertop,
parallel to the cutout opening using the supplied
mounting screws and butterfly nuts. Mounting screws
with brass inserts are supplied with the sink
,
however, countertop materials vary and the correct
type of fasteners should be recommended by your
installer or supplier.
7. Clean sink flange and underside of cutout area of
countertop, making sure that the area is smooth and
free from grease. Apply continuous bead of silicone caulk
evenly on top of sink flange. (Figure 5)
Figure 5
8. Position and align sink over the countertop opening
and press sink onto countertop. Turn bent end of
mounting bracket to snug over the sink rim. (Figure 6)
Figure 6
9. Check alignment of sink again and tighten fasteners
to secure sink.
10. Wipe away excess silicone caulk with a damp cloth. Connect drain and water supply according to
manufacturer's instructions.
5. Locate and drill holes on the underside of the counter top,
approximately 1" from edge of the sink to be installed.
Holes should be evenly spaced approximately 6" to 8"
apart starting from every corner as shown in Figure 4.
It is recommended to install a faucet at this point before
installing the sink.
Figure 4
3