Factory Direct Hardware Pfister GT48-GL0 - Manual (Page 4)

ENGLISH
ENGLISH
MAINTENANCE & CARE
13
15
14 CAUTION: Maintenance
DISASSEMBLY
1. Replacement parts may be available at the store where you purchased
your faucet.
2. When replacement parts are not available, please write or call Price
Pfister Consumer Service.
3. Always turn off water and relieve pressure before working on your
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp
cloth to clean and shine. Use of polish, detergents, abrasive
cleaners, organic solvents or acid may cause damage. Use of
other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar
substance are not acceptable for public areas or Commercial
use. Installation of Said Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pricepfister.com
• Installation Support
• Care and Warranty Information
13 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Cartridge (13A) by using Removal Tool
(13B). Turn Valves (13C) on and allow both hot and cold water to run for at least one
minute each. While water is running, check for leaks. Clean Aerator Cartridge (13A).
Once parts have been cleaned, reassemble by reversing steps.
14 HANDLE INSTALLATION REMOVAL
Turn off water before proceeding! Be sure Valves are in the “OFF” position. Remove
handles by holding the Lever (14A) in place and loosen the Hubs (14B) by rotating them
in a counterclockwise direction. To attach handles, rotate Hubs (14B) in a clockwise
direction.
15 VALVE CARTRIDGE MAINTENANCE
Turn off water supplies and relieve pressure before working on your faucet.
Remove handles (See Step 14), unscrew Cartridge Assembly (15A) and inspect. Replace
parts as necessary. Reassemble parts by reversing steps.
4
13A
13B
13A
13C
14A
14B
14B
14A
15A
sample
copy