Factory Direct Hardware Pfister GT48-GL0 - Manual (Page 3)

ENGLISH
ENGLISH
10
8
9
DRAIN BODY INSTALLATION
11
12
FAUCET FUNCTIONS
7
8 WATER SUPPLY CONNECTIONS
Connect water Supply Lines (8A) to Faucet Inlets (8B). Hot water supply lines go into
left inlet. Cold water supply lines go into right inlet. (Supply lines are not included).
Please follow manufacturer’s instructions when installing suppy lines.
9 POP-UP ROD CONNECTION
Insert Lift Rod (9A) into hole at the back of Spout (9B). Gently, slide Lift Rod (9A) down
the hole in Spout Hub (9B).
7 SECURING FAUCET
Align Faucet (7A) to sink surface. From underneath sink, secure Faucet using Wingnuts
(7B). Hand tighten.
10 POP-UP INSTALLATION
Install and adjust Pop-Up (10A) using separate instructions supplied with the Pop-Up
assembly.
11 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
12 VALVE FUNCTION
COLD valve: close-counterclockwise, open-clockwise; HOT valve: close-clockwise,
open-counterclockwise.
Note: Flush faucet before turning on valve (see step 13).
3
7B
7B
7A
7A
8A
8A
9B
10A
8B
8B
9A
OPEN
HOT
HOT
COLD
COLD
OPEN
sample
copy