Connecting the system din cable, System connections – PolyPlanar RD44 User Manual
Page 7
1352 Charwood Road • Suite D • Hanover, MD 21076 • Tel (410) 761-4000
www.polyplanar.com
7
The RD-44 connects to the system using a single cable with watertight
ends available in 10ft (3m), 20Ft (6m) and 60ft (18m) lengths. These
cables can be used in any combination to provide the needed
connection length.
The
RD44
can
be
used
in
several
Connecting the System DIN
Cable
The DIN cable is “Keyed” to prevent
misalignment and all connections are
gender specific
Leave the end caps on when routing to
prevent damage or contamination to the
leads. The cap is designed for pulling
through wire conduits.
The blue connector cap ends can be
discarded if a smaller diameter is
required such as a Pod mount. Use
shrink tube to seal the connections.
(Connector cap ends removed)
Before drilling holes for cable runs be sure there is sufficient room behind the
area. Always disconnect power before drilling around electrical connections.
Without = ½” (13mm) Ø
With ends = 7/8” (22mm) Ø
Be sure to use Grommets or other types of chafe protection when routing
cables through fiberglass or metal bulkheads or instrument pods.
The hole diameter requirements:
Provide strain relief by securing
cables with proper cable ties
System Connections