PolyPlanar MS55s - Manual (Page 4)

4
POLY-PLANAR • PO Box 409 • Hanover, MD 21076
Tel: (410)761-4000 • Fax: (410) 761-6274 • www.polyplanar.com
POLY-PLANAR products are warranted to be free of defects in materials
and workmanship for a period of two years. Warranty is subject to proper
installation and operation within published specifications. Poly-planar
will repair or replace, at its discretion, any unit returned prepaid to its
factory and determined to be defective. Poly-planar is not liable for
consequential damages.
Warranty
1) If the bass output is low, muffled or distorted, the speaker wires are
most likely hooked-up out of phase. Make sure the polarities of the
wires are correct with respect to the amplifier’s outputs.
2) Buzzing or rattling of the enclosure: Make sure that the rubber isola-
tion grommets (feet) are installed properly and that the enclosure is
securely fastened to a flat surface.
3) Too much or too little bass: Experiment with the placement of the
MS-55. Firing it into corners and walls tends to increase the amount
of sound while moving it away will reduce the output.
Troubleshooting
Specifications
Speaker Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Dual 4 ohm
Power Handling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100W rms
Dimensions (approx. w/h/d) . . . . . . . . . . . . .8.875 X 4.75 X 11.75 inches
225 X 121 X 298 mm
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.5 lbs ( 3 Kg)