Factory Direct Hardware Hansgrohe 18010001 - Manual (Page 4)

4
Slide the compression nut, cone washer, metal washer,
and rubber washer over the end of the supply hose.
Place the supply hose in the filter.
Tighten the compression nut to the filter, using two wrench-
es, as shown in the diagram, to prevent the supply hose
from twisting.
Install the pull rod (model 18210001 only).
Install the pop-up drain (model 18210001 only).
Turn on the water and check all connections for leaks.
18210001 only: Secure the supply hoses to the stops
with /8” compression fittings (not included). Use two
wrenches, as shown, to keep the hoses from twisting.
Turn on the water and check all connections for leaks.