Factory Direct Hardware Hansgrohe 18010001 - Manual (Page 3)

Product Specification
Max. Flow Rate 2.2 gpm
Max. incoming water pressure 145 psi
Recommended water pressure 14.5 - 72 psi
Max. hot water temperature 176 o F*
Recommended hot water temp 120 o F - 140 o F*
Hole size in mounting surface
18010001 1 1/4”
18210001 1 /8”
Max. mounting surface thickness 1 5/8”
Model 18010001 has 10 mm supply hoses -- 10 mm - /8” adapters included.
No drain or pull rod is included with model 18010001. Grid drain 06400000 (not included) is
recommended.
Model 18210001 has /8” supply hoses. /8” compression fittings are required (not included).
A pop-up drain is included with 18210001.
*Know and follow all applicable local plumbing codes when setting the temperature on the water heater. In Massachusetts,
the water heater may be set no higher than 112 o F.
Installation
Position the faucet and sealing ring on the mounting
surface.
From beneath the mounting surface, install the fiber
washer, metal washer, and mounting nut. Tighten the
tensioning screws.
18010001 only: Install the adapters on the stops.
Install the filters on the adapters.