Factory Direct Hardware Hansgrohe 39115 - Manual (Page 6)

6
Measure the distance from the outside surface of the
finished wall to the spout port (“X”). Add ” to X.
Measure the spout connector. Using proper tools
and safety practices, cut the spout connector so that
it is X + ” long.
Wrap the threads on the spout connector with
several layers of a Teflon tape. Screw the spout con-
nector into the rough.
Place the face plate against the wall. Screw the
sleeve/escutcheon retainer assemblies through the
plate and into the rough.
x + ”