Factory Direct Hardware Hansgrohe 39115 - Manual (Page 2)

Axor Citterio Wall-Mount Lavatory Trim
39115XX1
Technical Data
Max. water pressure 145 psi
Recommended pressure 14.5 - 7 psi
Recommended hot water temp 10°F - 140°F*
Flow rate 1.5 gpm
The hot and cold supplies must be of equal pressure for proper operation of the faucet.
*Know and follow all applicable local codes when setting the temperature of the water heater.
Installation Considerations
Rough-in 38111181 (purchased separately) must be installed and the finished wall complete
before installation of this trim kit. The outside surface of the finished wall must fall between the
"min" and "max" lines on the plaster shields. If the valve is too far inside the wall, purchase
extension kit 3898000 before attempting to install this trim kit.
For best results, Hansgrohe recommends installation by a licensed, professional plumber.
No drain is included with this faucet. Contact the manufacturer of the sink for recommenda-
tions regarding suitable drains.
Recommended tools (not included)
7 mm & 17 mm deep sockets
1 mm allen wrench
Teflon tape
cutting tools
waterproof sealant
•
•
•
��������
���
���
��
���
��
���
��