Pfister GT42-ANCC User Manual

Page 3

6 WATER SUPPLY CONNECTIONS

Thread the ½” NPSM Adapter (6A) into the ⅝” Nut (6B). Tighten using

wrenches on both the Adapter and the Nut. Make connection to the Faucet

Inlet (6C). Repeat for the other tube. Connect water Supply Lines (6D) to

Faucet Inlets (6C). (Supply lines and fi ttings are not included).

7 SOAP DISPENSER INSTALLATION

Insert threaded Shank (7A) of soap dispenser body through Rubber Gasket

(7B) and sink hole. Tighten Nut (7C) and thread on Bottle (7D) to Shank (7A).

8 SOAP DISPENSER HEAD INSTALLATION

Pour liquid soap (not included) into the Shank Opening (8A). Install Dispenser

Mechanism (8B) into Dispenser Head(8D). Insert Dispenser Head (8D) and

Dispenser Mechanism (8B) into Soap Dispenser Body (8C).

9 POP-UP ROD CONNECTION

Insert Lift Rod (9A) into hole at the back of Spout Hub (9B). Gently, slide Lift

Rod (9A) down the hole in Spout Hub (9B).

POP-UP DRAIN BODY INSTALLATION STEPS

10 ALL METAL POP-UP INSTALLATION

Apply a small bead of plumber’s putty underneath the Flange (10A) and place

a ring of putty around Drain Opening (10B) of sink. Use PTFE plumber’s tape

on all threaded fi ttings according to manufacturer’s instructions. Insert Flange

(10A) into Drain Opening (10B). From underneath, thread Drain Body (10C) to

bottom of Flange (10A). Thread Locknut (10D) until Rubber Washer (10E) seats

securely inside Drain Opening (10B). Hand tighten and adjust the Drain Body

so that the Ball Rod Opening (10F) faces the rear. Wipe excess putty.

ENGLISH

10A

10B

10C

10D

10F

10E