Factory Direct Hardware Hansgrohe 34010 - Manual (Page 3)

3
Installation Considerations
For best results, Hansgrohe recom-
mends that this unit be installed by
a licensed, professional plumber.
Please read over these instructions
thoroughly before beginning instal-
lation. Make sure that you have
all tools and supplies needed to
complete the installation.
This faucet can be used with a
continuous flow water heater if the
flow pressure is at least 20 psi.
•
•
•
Technical Information
Recommended water pressure 14.7 - 72.5 psi
Max. water pressure 145 psi
Recommended hot water temp. 120� - 140� F*
Max. hot water temp 165�F*
Hole size in mounting surface 1 3/8"
Max. mounting surface depth 1 5/8"
Flow rate 2.2 gpm
Cartridge with high temperature limit stop
3/8" supply hoses - requires 3/8" compression fitting
(not included)
*Please know and follow all applicable local plumbing codes when setting
the temperature on the water heater.
34120XX1 34127XX1