Factory Direct Hardware Hansgrohe 10175001 - Manual (Page 6)

6
Connect the faucet power cable to the
battery pack or AC power pack (1). Plug
the AC power pack in.
Turn the hot and cold supplies on ().
Remove the protective film from the sensor
window ().
Wait 0 seconds before attempting to use
the faucet (4).
Position your hand in front of the sensor
to turn the water on.
Due to air in the faucet, the spray pattern
may be unattractive for the first 10 - 15
uses after installation or service.
Models with manual temperature
adjustment only: pull the temperature
lever forward to make the water cooler,
backward to make it warmer.
Temperature adjustment - 10106XX1/10145XX1/10175001/10185001 only
Turn the water supplies off (1).
Disconnect the faucet power cable from the battery pack
or AC power pack ().
Remove the screw from the rear of the faucet ().