Factory Direct Hardware Hansgrohe 04066LF Allegro E - Manual (Page 5)

5
English
5
Install the handspray hose
Connect the supply hoses
Connect the supply hoses to the stops. Use two
wrenches, as shown in the diagram, to keep the sup-
ply hose from twisting.
Do not allow either hose to twist.
Twisting the supply hose may cause
it to loosen from the faucet, which
may cause water damage.
Twisting the handspray hose may
cause reduced water flow to the
handspray.
Slide the nut, cone washer, brass washer and black
rubber washer over the end of the connecting hose.
Hold the handspray hose steady while tightening the
nut. Finish tightening the nut with a wrench.
Do not allow either hose to twist.
Twisting the supply hose may cause
it to loosen from the faucet, which
may cause water damage.
Install the hose weight
Proper positioning of the hose weight insures that
the hose will retract smoothly.
Install the hose weight on the handspray hose.
Pull the hose out and guide it back into position. If
it does not retract smoothly, or the sprayhead does
not stay in place when resting in the spout, reposi-
tion the weight.
Turn on the water and check all connections for
leaks.