Factory Direct Hardware Hansgrohe 04066LF Allegro E - Manual (Page 4)

4
English
4
Tighten the mounting nut and screws.
Allegro E Kitchen & Prep Faucets
Installation Considerations
For best results, Hansgrohe recommends that this unit be installed by a licensed, profes-
sional plumber.
Please read over these instructions thoroughly before beginning installation. Make sure
that you have all tools and supplies needed to complete the installation.
Protection against backflow provided by check valve.
The supply hoses connect to the stops with 3/8" compression fittings (not included).
•
•
•
•
Installation
Remove the mounting nut, metal washer, fiber
washer and spacer from the faucet.
Place the faucet with sealing ring on the mounting
surface.
If the mounting surface is less than 1 3/8” thick,
install the gray plastic spacer. If the mounting
surface is greater than 1 3/8”, or if there is
insufficient space, omit the spacer.
Install the fiber washer, metal washer and
mounting nut.