Factory Direct Hardware Hansgrohe 39148 - Manual (Page 5)

5
Wrap the threads on the spout connector with several
layers of Teflon tape. Screw the spout connector into
the port.
Measure the spout connector. It should extend from
the wall 1 3/8”
Connect the spout escutcheon and spout to the
baseplate. Use a 3 mm Allen wrench to tighten the
screws.
Push the baseplate assembly over the valves and
spout connector.
Hold the handle escutcheon in place on the baseplate.
Push the handle into place. Rotate the handle
base clockwise, until it threads down over the slip
connector.