Dexter Laundry T-30 (On-Premise) - Manual (Page 20)

- 20 -
PROCEDURE:
1) After the load has been placed in the dryer, press and release either the UP or DOWN touch pad switch on
the dryer controller until the L.E.D. for dry cycle 1 is illuminated.
2) Press and release the PROG touch pad switch on the dryer controller. The display of the dryer controller
will not change.
3) Immediately, press and release the UP touch pad switch on the dryer controller. The controller display will
change from “L0Ad” to “Prog”. You have now entered the permanent programming mode. The dry time
L.E.D. will remain on and the programming L.E.D. will illuminate.
4) Press and release the SELECT/ENTER touch pad switch once. The dry time L.E.D. and programming
L.E.D. will remain on, the dry time L.E.D. will illuminate, and the dryer controller will show the number
“35”.
5) Press the UP touch pad switch 18 times until the display of the dryer controller shows the number “53”.
6) Press and release the SELECT/ENTER touch pad switch of the dryer controller once. The dry time L.E.D.
and programming L.E.D. will remain on, the dry time L.E.D. will switch off, the temperature L.E.D. will
illuminate, and the dryer controller display will show the number “180”.
7) Press and release the UP touch pad switch three times until the dryer controller display shows the number
“195”.
8) Press and release the SELECT/ENTER touch pad switch of the dryer controller. The dry time L.E.D. and
the programming L.E.D. will remain on, the temperature L.E.D. will switch off, the cool down L.E.D. will
illuminate, and the dryer controller display will show the number “5”.
9) Press and release the DOWN touch pad switch twice until the dryer controller display shows the number “3”.
10) Press and release the SELECT/ENTER touch pad switch of the dryer controller. The dry time L.E.D. and the
programming L.E.D. will remain on, the cool down L.E.D. will switch off, and the dryer controller display will
change to “Prog”.
11) Press and release the STOP touch pad switch of the dryer controller. The dry time L.E.D. will remain on,
the programming L.E.D. will switch off, and the dryer controller display will change to the word “LOAd”.
The dryer is now ready for the new modified dry cycle to start. This modified dry cycle 1 program will remain
in the dryer controller memory until the default settings push button is pressed. This default setting push button
is located on the component side of the dryer controller printed circuit board at the lower middle side.