Dexter Laundry T-30 (On-Premise) - Manual (Page 14)

- 14 -
4-DIGIT NUMERICAL DISPLAY MESSAGES
Description
LOAd This message is displayed after a dry cycle is complete and the dryer loading door
has been opened or the STOP touch pad switch on the dryer controller has been
pressed and released twice.
donE This message blinks immediately after completion of the dry cycle and continues to
blink until the STOP touch pad switch on the dryer controller is pressed or the dryer
loading door is opened.
Prog
This message is displayed when entering the permanent programming mode.
.15 This message appears while the dryer is in the heating time of a dry cycle. The
decimal point will blink if the output for the gas valve is on, or remain on constantly
if the output for the gas valve is not on. The number represents the total time left
in the dry cycle (includes cool down time).
C02 This message appears when the cool down time of the dry cycle is reached. The
letter “C” represents the cool down (non-heating) part of the dry cycle. The
number(s) after the letter “C” represent(s) the total time remaining in the dry cycle.
F5
This message appears if there is a dryer fault. The letter “F” indicates a fault and
the number after the “F” represents the specific fault that has occurred. There are
five different faults that can appear (F1 through F5).