Dexter Laundry T-30X2 EXPRESS - 60 Hz Gas (On-Premise) User Manual
Page 22
22
2) Press and release the PROG touch pad key on the dryer controller. The dryer controller display will
not change.
3) Immediately, press and release the UP arrow key on the dryer controller touch pad. The controller
display will change from “LOAd” to “Prog”. You have now entered the permanent programming
mode. The dry time L.E.D. will remain on and the programming L.E.D. will illuminate.
4) Press and release the SELECT/ENTER touch pad key once. The dry time L.E.D. and programming
L.E.D. will remain on and the dry time L.E.D. will illuminate. The dryer controller will also show the
number “35”.
5) Press the UP arrow touch pad key 18 times until the dryer controller display shows the number “53”.
6) Press and release the SELECT/ENTER touch pad key once. The dry time L.E.D. and programming
L.E.D. will remain on and the dry time L.E.D. will switch off. The temperature L.E.D. will illuminate
and the dryer controller display will show the number “180”.
7) Press and release the UP arrow touch pad key three times until the dryer controller display shows the
number “195”.
8) Press and release the SELECT/ENTER touch pad key. The dry time L.E.D. and the programming
L.E.D. will remain on and the temperature L.E.D. will switch off. The cool down L.E.D. will
illuminate and the dryer controller display will show the number “5”.
9) Press and release the DOWN arrow touch pad key twice until the dryer controller display shows the
number “3”.
10) Press and release the SELECT/ENTER touch pad key. The dry time L.E.D. and the programming
L.E.D. will remain on and the cool down L.E.D. will switch off. The dryer controller display will
change to “Prog”.
11) Press and release the STOP touch pad key. The dry time L.E.D. will remain on and the programming
L.E.D. will switch off. The dryer controller display will change to the word “LOAd”.
The dryer is now ready for the new modified dry cycle to start. This modified dry cycle 1 program will
remain in the dryer controller memory until the default settings push button is pressed. This default
settings push button is located on the component side of the dryer controller printed circuit board at the
middle center side of each circuit board controls.