dbx 286s - Manual (Page 3)

286
DecLaratIon of
conforMIty
manufacturer’s Name: dbx professional products
manufacturer’s Address: 8760 s. sandy parkway
sandy, utah 84070, usA
declares that the product:
product name: dbx 286s
Note: product name may be suffixed by the eu.
product option: None
conforms to the following product specifications:
safety: iec 60065 -01+Amd 1
emc: eN 55022:2006 (N/A; Analog product)
iec61000-4-2
iec61000-4-3
iec61000-4-4
iec61000-4-5
iec61000-4-6
iec61000-4-8
iec61000-4-11
supplementary information:
the product herewith complies with the requirements of the:
Low Voltage directive 2006/95/ec
emc directive 2004/108/ec
rohs directive 2002/95/ec
Weee directive 2002/96/ec
With regard to directive 2005/32/ec and ec regulation
1275/2008 of 17 december 2008, this product is designed,
produced, and classified as professional Audio equipment and
thus is exempt from this directive.
roger Johnsen
Vice-president of engineering
8760 s. sandy parkway
sandy, utah 84070, usA
date: september 10, 2010
european contact: Your local dbx sales and service office or
harman music Group
8760 south sandy parkway
sandy, utah 84070, usA
ph: (801) 566-8800
Fax: (801) 568-7583
eLectroMaGnetIc
coMPatIBILIty
this unit conforms to the product specifications noted on the
Declaration of Conformity. operation is subject to the following two
conditions:
• this device may not cause harmful interference, and
• this device must accept any interference received, including
interference that may cause undesired operation.
operation of this unit within significant
electromagnetic fields should be avoided.
• use only shielded interconnecting cables.
u.K. MaInS PLuG WarnInG
A molded mains plug that has been cut off from the cord is unsafe.
discard the mains plug at a suitable disposal facility.
NEVER UNDER ANY CIRCUMSTANCES SHOULD YOU
INSERT A DAMAGED OR CUT MAINS PLUG INTO A 13
AMP POWER SOCKET.
do not use the mains plug without the fuse cover in place.
replacement fuse covers can be obtained from your local retailer.
replacement fuses are 13 amps and must be AstA approved to
Bs1362.
IMPORTANT SAFETY INFORMATION