GPK UPPERTONE User Manual

Page 15

F: Rowing Lever Assembly (Figures 1 & 8):

1. Insert Bearings (65) into tubes as shown. Attach Rowing Levers (5) to Frame Base (2) by

inserting shaft on Rowing Levers into Bearings (65) at end of Frame Base (2). Secure with Shaft
Collar (32) by sliding Shaft Collar over exposed shaft and tightening the set-screw with a 5/32
Allen wrench. Both Rowing Levers (5) should rest almost vertically against stops.

NOTE: THE FOLLOWRNG INSTRUCTIONS (1.a through 1.i.) APPLY TO BOTH ROWING
LEVERS.

a. Insert Rowing Adjuster (7) into Rowing Lever (5). Attach Wing Handle (12) by threading

into Rowing Lever (5) as shown. This Handle holds Rowing Adjuster at the desired
height.

b. Slide Rowing Arm (8) into Rowing Adjuster (7).

c. Attach Tri-Pin Plate (11) to Rowing Arm (8).

d. Attach Pegs (10) to Tri-Pin Plate (I 1) using 3/8 Hex Bolts (45), washers (67) and lock

washers (3). Slide Foam Pads (73) over Pegs (Use lubricant such as liquid soap).

e. Install Plugs (37) to ends of Rowing Arm (8) and screw in the bumper (4) with the 10-24

hex nut (9).

f. Mount Pulley (14) into Pulley Bracket (13) with the 3/8” Hex Bolt (47). Attach Pulley

Bracket (13), with Pulley (14), to Rowing Lever (5).

G: Cable Set-Up (Figures 9, 10, & 11)

NOTE: THE CABLE ASSEMBLY IS ALL ONE PIECE WITH AN EYEBOLT CONNECTED AT
THE CENTER.

Also Note: You should install the cable with the “Front” sticker facing you. And when you have
finished putting on the cable, as shown in Figure 8 there should be a gap of 1” to 2” between the
truck arms and stop. If you do not have this gap, the cable is incorrectly installed.

2. Attach Eyebolt (holding both sides of Cable Assembly (33) ) to top of Frame Post (3) using 3/8

Hex Nut (42).

3. Run one end of cable down inside Pulley (14) attached to bracket on Deltoid/Lat Slider (6).

4. Run cable outside of Pulley on Vertical Swing Plate (26).

5. Continue to run cable down inside and under Pulley (I 7).

6. Run cable over the Pulley (14) on the Horizontal Swing Plate (26).

7. Continue under fixed Pulley (14) on Deltoid/Lat Slider.