Derale Performance Single Mount 1_2" NPT Ports Up Fuel Filter_Water Separator Kit - Manual

13072-InstructionSheet
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
INSTALLATION INSTRUCTIONS
FUEL FILTER - WATER SEPARATOR KIT
PART # 13072
Please read these instructions completely before starting the installation.
Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on
vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the
parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting
the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.
Failure to follow instructions can lead to severe damage and personal injury.
KIT CONTENTS
QTY. DESCRIPTION
1 Filter Mount
1 Oil Filter
TOOLS NEEDED
QTY. DESCRIPTION
1 3/4-16 Filter Nipple
INSTALLATION
1. Choose a convenient location for the filter mount and
filter, making sure you allow enough space for servicing
the petcock and for replacing the filter element.
Suggested locations are the fender well, firewall or
the radiator bulkhead.
2. Mark and drill three holes and mount the filter bracket using the hardware provided.
3. Install the fuel inlet and outlet lines into the appropriate ports. Do not over tighten.
4. Apply a light coat of clean oil to the gasket on the fuel filter-water separator and hand-
tighten it on to the filter mount. Once the filter is snug to the filter mount, tighten the
filter 1/4” turn; therefore assuring that the filter will not leak. Filter element should be
replaced every 25,000 miles. Order Derale replacement filter element part #13075.
The water should be drained every 3,000 miles. Both intervals should be shortened if
the fuel being filtered is suspected of containing high levels of contaminants and/or
water.
5. Start engine and check all connections for leaks. Re-tighten if necessary. The Fuel
Filter-Water Separator is designed for use with most fuels: gasoline, diesel fuel,
gasohol, etc. and most additives.
Drill
3/16” Drill Bit
Teflon Tape
Marker
FILTER SPECIFICATIONS
12 Micron
1”-14 Thread Size
Filter Seal
ID: 2.45” OD: 2.80”
22 Gram Capacity 100 psi Element
Burst Pressure
300 psi Hydrostatic
Burst Pressure
Rev-081111