Derale Performance Dodge Deep Transmission Pan Filter Extender - Manual

14010-InstructionSheet
INSTALLATION INSTRUCTIONS
DODGE TRANSMISSION FILTER EXTENDER
PART # 14010
KIT CONTENTS
QTY. DESCRIPTION
1 1” Spacer Block
1 O-ring
3 10-24 x 2 1/4” Bolts
3 10-24 x 3 1/2” Bolts
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
Please read these instructions completely before beginning installation
Dodge / Chrysler
Transmissions
A727, A904, A518 & A618
TOOLS NEEDED
5/32” Allen Wrench
Torque Wrench
5/32” Allen Socket
Lint free rag
REMOVING TRANSMISSION FILTER
INSTALLING FILTER EXTENDER
1. Using the proper tools, remove the bolts holding on the factory filter.
Be careful when removing because the filter will still have fluid inside.
2. Disregard factory bolts.
Note:
Note:
Note:
It is recommended to replace the current filter with a new Transmission filter.
1. Using a lint free rag, wipe the oil off the valve body mounting surface.
2. Install the O-ring provided in the groove of the 1” Spacer Block.
The kit includes two sets of bolts that will accommodate the four transmissions listed above, you will not use all
bolts supplied.
3. After determining which length bolts are necessary for your transmission, install the bolts through the provided washers,
through the Transmission Filter, through the 1” Spacer Block and then hand tighten onto the valve body.
(See Diagram #1)
4. Using a 5/32” Allen Wrench, tighten the bolts.
5. Torque the bolts to a maximum of 14 inch pounds.
6. Install transmission pan and fluid.
Diagram #1
QTY. DESCRIPTION
3 #10 Flat Washers
APPLICATION
1” Spacer Block
O-ring
#10 Flat
Washer
10-24 x 2 1/4” Bolts or
10-24 x 3 1/2” Bolts
Filter
(Not Included)
Transmission
3 Mounting Holes