R&M Materials Handling END TRUCKS BRIDGE DRIVES WHEEL BLOCKS GES Drive Manual User Manual
Page 2
R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
%
: (937) 328-5100
FAX: (937) 325-5319
2/11
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
EN PS01645 Rev: 07.10.02
I
Read the instructions supplied with the hoist before installation and commissioning.
F
Keep the instructions in a safe place for future reference.
Table of content
1
Instructions..................................................... 3
1.1
Symbols and abbreviations ......................... 3
2
Safety instructions......................................... 3
2.1
Safety instructions for preparing to install
the drive................................................................. 3
2.2
Safety instructions for installing and
operating the drive ................................................ 3
2.3
Safety instructions for servicing the drive ... 4
3
GES Drive........................................................ 4
3.1
General ........................................................ 5
3.2
Mounting position of the drive ..................... 5
3.3
Assembling the drive ................................... 5
3.4
Start-up procedure....................................... 6
3.5
Inspection and service procedure for Drive 6
3.6
Removing the drive ..................................... 7
4
MF06 motor with Compact or DC brake...... 7
4.1
Adjustment of Compact-brake air gap ........ 8
4.2
Removing the Compact-brake .................... 8
4.3
Removing and inspection of DC brake ....... 8
4.4
Removing the motor................................... 9
5
MF07 and MF10 motor................................... 9
5.1
Removing and inspection of DC brake ..... 10
5.2
Removing the motor.................................. 10
6
Lubricants..................................................... 10
6.1
Alternative lubricants ................................. 11
7
Recommended tightening torques............ 11
8
Inspection and servicing intervals............. 11