AEG SKS68808F0 User Manual
Page 32
Problem
Possible cause
Solution
The door has been opened too
frequently
Do not leave the door open longer
than necessary
Food placed in the appliance was
too warm
Allow food to cool to room tem-
perature before storing
The temperature of the room
that contains the appliance is
too high for efficient operation
Try to reduce the temperature in
the room where the appliance
stands
The sound level in the
cabinet is too high
The pipes, at the back of the
cabinet, touch each other
Carefully bend them
Water flows at the back
plate of the refrigerator
During automatic defrosting,
frost melts on the back plate
It is normal
Water flows into the re-
frigerator compartment
The outlet can be clogged up
Clean the outlet
Products placed in can prevent
water from flowing into the col-
lector
Replace the products so that they
can not touch the back plate di-
rectly
Water flows onto the
floor
The melting water outlet flows
not into the evaporative tray
above the compressor
Put the melting water outlet to
the evaporative tray
The lamp does not work.
The lamp is in stand-by.
Close and open the door.
The lamp is defective.
Refer to "Replacing the lamp".
It is too warm in the re-
frigerator
The Temperature regulator may
be set incorrectly
Set a lower temperature
The door does not close tightly
or it is not shut properly
Check if the door closes well and
the gasket is undamaged and
clean
Food placed in the appliance was
too warm
Allow food to cool to room tem-
perature before storing
Large quantities of food to be
cooled were put in at the same
time
Insert smaller quantities of food
to be cooled at any one time
There is no inside cool air circu-
lation
Provide inside cool air circulation
It is too cold in the refrig-
erator
The Temperature regulator may
be set incorrectly
Set a higher temperature
The appliance does not
work at all. The appliance
does not cool at all. Nei-
ther cooling nor lighting
works
The appliance may be switched
off
Switch on the appliance
Plug is not connected to the
mains socket properly
Connect the mains plug properly
32
What to do if…