KIA Sedona 2009 - Manual (Page 208)

3 199
Features of your vehicle
How to Use SIRIUS Satellite
Radio
Your Kia vehicle is equipped with 3 months
complimentary period of SIRIUS Satellite
Radio so you have access to over 130
channels of music, information, and enter-
tainment programming.
Activation
In order to extend or reactivate your sub-
scription to SIRIUS Satellite Radio, you
will need to contact SIRIUS Customer
Care at 888-539-7474. Have your 12 digit
SID (Sirius Identification Number)/ESN
(Electronic Serial Number) ready. To
retrieve the SID/ESN, turn on the radio,
press the [SAT] button and tune to chan-
nel zero. Please note that the vehicle will
need to be turned on, in Sirius mode, and
have an unobstructed view of the sky in
order for the radio to receive the activa-
tion signal.
1. SATELLITE RADIO Selection
Button(SIRIUS Satellite Radio)
Press the [SAT] button to switch to SIR-
IUS Satellite Radio. It cycles through the
different bands as noted below.
SAT1
➟ SAT2 ➟ SAT3 ➟ SAT1 ➟ ...
2. Channel Selection Button
• Press [SEEK ] or [SEEK ] button
for less than 0.8 second to select pre-
vious or next channel.
• Press [SEEK ] or [SEEK ] button
for 0.8 or longer to continuously move
to previous or next channel.
• If "CATEGORY" Icon is displayed at
the top of the screen, channel up/down
is done through the channels within
current category.
3. Preset Selection Button
• Push [1]~[6] buttons less than 0.8 sec-
ond to play the channel saved in each
button.
• Hold down the preset button for 0.8
second or longer to save current chan-
nel. An audible beep will play to con-
firm the preset is stored.
4. SCAN Button
• When the button is pressed, it auto-
matically scans the radio stations
upwards.
• The SCAN feature steps through each
channel, starting from the initial chan-
nel, for ten seconds.
• Press the [SCAN] button again to stop
the scan feature and to listen to the
currently selected channel.
• if "CATEGORY" Icon is displayed at the
top of the screen, channel changing is
done through the channels in current
category.
5. Tune knob and Enter button
• Turn this button clockwise by one notch
to increase the channel.
• Turn this button counterclockwise by
one notch to decrease the channel.
• Press this button while holding SETUP
button to activate / deactivate the item
to. Select SETUP item using left and
right function of the Tune button.