KIA Borrego 2008 - Manual (Page 341)

6 13
What to do in an emergency
Operating the jack
To raise the jack:
1. Check whether the jack valve is
closed. If not, insert the jack han-
dle into the valve and turn it clock-
wise until it is closed.
2. Insert the jack handle into the
pump bracket.
3. Pump the jack handle up and
down until the ram is raised to the
desired level.
To lower the jack:
1. Insert the jack handle into the
valve and turn it counterclockwise
until it is opened. Do not turn it
more than twice.
2. Push the ram in by pushing the top
of the ram.
3. When the ram is completely low-
ered, insert the jack handle into
the valve and turn it clockwise and
close it.
OHM068020 OHM068021
CAUTION
This jack is hydraulic, and the
ram is a two stage type. When
both rams are raised and the
stop mark of the upper ram
becomes visible, stop jacking
immediately.