PowerWalker VI 1000 - Manual (Page 7)

EN
II: Connect to Utility and Charge
Plug in the AC input cord to the wall outlet. For the best results, we suggest charging the battery at least 6
hours before initial use. The unit charges its battery while connecting to the utility.
III: Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn on the power switch of UPS
unit, and devices connected to the UPS will be protected by UPS unit.
IV: Connect Modem or Phone for Surge Protection
Connect a single modem or phone line into surge‐protected “IN” outlet on the back panel of the UPS unit.
Connect from “OUT” outlet to the computer with another phone line cable.
V: Connect USB Cable
To monitor the UPS status, such as unattended UPS shutdown and start‐up, by using bundled software,
please connect the UPS and PC with USB cable included.
Do not attach a power strip or surge suppressor to the UPS.