Peterson StroboPlus HD Metronome Manual User Manual
Page 8
Configuration Menu
This menu is used to reset your StroboPlus to factory default settings and find out what firmware and hardware
version the device has.
To enter the Configuration Menu, press the Power Button and the Mode Button at the same time.
The first setting to show will be C indicating the type of configuration currently loaded, either FDR= Factory
Default Reset or USR= User Configured. USR indicates that there has been a user configuration created on the
PetersonConnect™ site and loaded into the device. While the “C” is flashing, to return to the factory default
configuration, press the Select Knob once, select FDR by turning the Select Knob, and then press the Select
Knob once again. If only -- -- -- is shown, there is no user configuration in this device.
Rotating the Selector Knob while C is flashing will next show F and the firmware that is currently installed in
your tuner. There will be three numbers which indicate the installed firmware version.
When you rotate the Select Knob again, the “H” screen will indicate the hardware version of this device.
To exit the Configuration Menu, press the Mode Button.
© 2013 Peterson Electro-Musical Products, Inc.
11601 S. Mayfield Avenue, Alsip IL 60803-2476 USA 1-708-388-3311