Assembly, Warning, Important – BabyTrend PY90918 - MINI NURSERY CENTER - TWILIGHT User Manual

Page 8

ASSEMBLY

Attach playard w/ Close N

Cozy to bed

WARNING:

STRANGULATION /

SUFFOCATION HAZARD:

The top rail of the playard must

be at or below the top of the adult

bed mattress when used with

Close N Cozy.

WARNING:

STRANGULATION HAZARD:

When anchor buckle and strap

assembly is not in use, store in a

safe place not accessible to children.

1. Separate mattress from box spring.
2. Position Playard on the desired side of the bed.
3. With hooks positioned on the same side of the

playard (Fig. 46), layout one strap set UNDER

the bed fame and the other strap set ON TOP of

the box spring. Fully extend both straps to the

opposite the side of the bed. (Fig. 47)

4. Attach the strap hooks to the playard legs by

hooking the straps to their corresponding

upper and lower positions at the front of the

playard. (Fig. 48) To tighten the strap hooks,

use the adjustment buckle and make sure the

strap hooks stay in place while completing

steps 5, 6, and 7.

5. Connect the upper and lower strap sets at

the opposite end of the bed by fastening the

anchor buckle. (Fig. 49)

6. Position playard against the edge of the bed.
7. Secure playard against the side of the bed by

tightening the straps as tight as possible. The

playard must be securely positioned against

the bed before use.

Note: Set brake on Playard Wheels by

pressing downward on the brake levers.

Important: Never use the Close N Cozy

feature without the playard securely fastened

to the bed.

8. Place mattress back onto box spring.

Your playard with Close N Cozy feature is now

ready to use.

Fig. 47

Fig. 46

IMPORTANT!

Never use this product without the anchor

buckle attached and locked as shown. Failure to use this anchoring

system could result in serious injury or death to the infant. Make sure

all straps are secured and tight. Check straps before each use.

IMPORTANT!

Failure to use this securing system will allow

Close N Cozy to move away from adult bed and could result in infant

falling out.

IMPORTANT!

NEVER leave infant unattended.

ATTENTION: Before attaching Close N Cozy to playard, you must

1. Playard, including side rails, must be fully erected prior to use.

Make sure latches are

secure.

Refer to playard's instruction for details.

2. Determine the height of adult bed first. Place a flat object on the top of the adult bed

(including base, springs and mattress) so that a few inches of it pass over the edge of the

adult bed. Messure down from this point to the floor to find the exact bed height. It is

recommended to use this feature with an adult bed with floor height 24" to 30".

Fig. 49

Fig. 48