Warning – BabyTrend 7556PLUS - SIT N' STAND PLUS STROLLE - SERENGETTI User Manual

Page 6

SEATBACK POSITIONING

1. The front seat has a two position recline. To recline the seat, rotate the

recline bar and press backward on the seat back. Fig. 19. To place the

seat in the upright position, press upward on the seat back while rotating

the recline bar.

2. The upright position should be used only for a child that is at least 6

months old. Note: Seat does not fully recline.

3. To recline the rear seat locate the plastic adjuster and squeeze the ends.

Loosen or tighten the strap to your desired recline position. Fig. 20.

TO RECLINE SEATS

Fig. 19.

Fig.20.

WARNING!!!

Do not use jump

seat at this point. The harness strap must

be adjusted before proper and safe use

can commence. Read below for harness

adjustment.

STEP TWO: ADJUSTING SAFETY HARNESS

1. Disconnect straps on jump seat that run underneath the Jump Platform.

2. Remove Jump Seat Pad. Crotch Buckle will fit through provided slots.

DO NOT REMOVE crotch Buckle.

3. Pull Crotch Buckle towards the rear of the Sit N Stand so that the buckle

will be orientated closer to the edge of the jump platform (Fig. 17).

STEP THREE: INSTALLING JUMP SEAT PAD

1. Feed Crotch Buckle through provided slot closer to the edge of the

Jump Pad.

2. Slide the pad over the front of the Jump Seat platform and into the front

pocket of the Pad cover.

3. Fold the Pad over the seat and secure the connecting velcro straps

together.

4. Have child sit on the jump seat facing backwards. Secure the seat belt,

which is attached to the back of the seat, around the child’s waist, and

buckle to the crotch strap. Fig. 12B. Adjust the seat belt to be snug around

the child’s waist.

5. To release, apply pressure to both sides of the male clip until the clip

is released. This process requires a moderate amount of effort so as to

prevent an accidental release by your child.

6. Be sure that the child’s feet are fully on the platform at all times.

When you are not using the jump seat harness, place it in the storage location

on the rear of the front seat. Fig. 18

Fig. 18

Fig. 15

Fig. 16

Fig. 17

D-ring