Warning – BabyTrend 7556PLUS - SIT N' STAND PLUS STROLLE - SERENGETTI User Manual

Page 5

1. The rear platform and jump seat are designed to accommodate a child

who is at least 2 1/2 years old, has good balance and coordination, and is

not over 40 inches tall. Position the child on the platform on the back of

the stroller. Be sure child is facing forward and hands are holding frame.

Secure the safety belt behind child and engage buckle. Fig. 12.

2. Be sure that the child’s feet are fully on the platform at all times.

PLEASE NOTE: When using the rear SEAT you must put the STAND

FEATURE SAFETY BELT in the storage location located on the rear of

the seat. Please See Fig. 12A

WARNING:

To avoid a possible

choking hazzard when using the rear seat, put

the STAND FEATURE SAFETY BELT in the

storage location on the rear of the seat.

TO SECURE REAR STANDING CHILD

Fig. 11.

Fig. 12.

Shoulder Strap

Squeeze

Crotch Strap

Waist

Strap

Adjust for a

snug fit

Fig. 10.

STEP ONE: REMOVING THE REAR SEAT

1. Unsnap Rear Canopy buttons from the back of the rear seat.

2. Remove the rear canopy by sliding the square fittings upward until they

disconnect from the frame.

3. Remove the rear seat from the frame by unbuttoning the upper and

lower seat back fabric from the frame (Fig. 13 & 14) and unsnapping

both front connection points (Fig. 15).

4. Detach the (2) shoulder straps from the frame by folding and sliding the

strap through the “D-Ring” located on the end of each strap (Fig 16).

5. Remove Rear Seat.

ATTENTION: Crotch strap will fit through the bottom of the Rear Seat, do

not remove crotch strap.

TO USE JUMP SEAT

Fig. 12A.

Fig. 12B.

Upper

Fig. 13

Fig. 14

Lower

Snap point