BabyTrend 1866CT - SAFARI BABIES TRAVEL SYSTEM User Manual
Page 4
* To attach the front child tray, push the angled tray onto the post at the
end of the right armrest, while pressing downward on the snap button,
until locked into place. Please see figure 7. Rotate the tray downward
until latched onto the left armrest. Please check that the snap button
comes through and securely latches the tray in place. Please see figure
8.
* To remove front child tray, press inward on the left side tray release
button and rotate upward on the tray. Please see figure 9. Please note
that you may remove the tray completely by depressing the snap button
on the right side as shown in figure 10 while pulling forward on the tray.
Please see figure 7.
* To install the canopy slide the male ends of the canopy into the female
slots on the stroller frame. Please see figure 11. To open the canopy
push forward on the front frame tube of the canopy. Please see figure
12.
* The stroller handle has multiple positions. To adjust the handle to your
desired position, press in both round buttons at each end of the handle.
Please see figure 13.
* To attach the parent tray line up the parent tray slots with the
corresponding slots on the stroller frame, slide down until it locks into
place. Check to make sure the parent tray is secure before using. Please
see figure 14
* To remove the parent tray, locate the locking tabs under the tray, pull
outward on the locking tabs and lift up to remove. Please see figure 15
4
Figure 9.
Figure 7.
Figure 8.
Figure 12.
Front frame
tube
Figure 10.
Figure 11.
Figure 13.
Figure 14.
Figure 15.