Rainbow Electronics DS2788 - Manual (Page 18)

D
S
2
7
8
8
All Control register bits are read and write accessible.
T h e C o n t r o l r e g i s t e r i s r e c a l l e d f r o m p a r a m e t e r
EEPROM memory at power-up. Register bit values can
be modified in shadow RAM after power-up. Shadow
RAM values can be saved as the power-up default val-
ues by using the Copy Data command.
Stand-Alone Fuel-Gauge IC with
LED Display Drivers
18 ______________________________________________________________________________________
Control Register
ADDRESS 60h BIT DEFINITION
Field Bit Format Allowable Values
NBEN 7 Read/Write
Negative Blanking Enable
0: Allows negative current readings to always be accumulated.
1: Enables blanking of negative current readings up to -25µV.
UVEN 6 Read/Write
Undervoltage SLEEP Enable
0: Disables transition to SLEEP mode based on V IN voltage.
1: Enables transition to SLEEP mode if V IN < V SLEEP and DQ are stable at either
logic level for t SLEEP.
PMOD 5 Read/Write
Power Mode Enable
0: Disables transition to SLEEP mode based on DQ logic state.
1: Enables transition to SLEEP mode if DQ is at a logic-low for t SLEEP.
RNAOP 4 Read/Write
Read Net Address Op Code
0: Read net address command = 33h.
1: Read net address command = 39h.
DC 3 Read/Write
Display Control
0: Enables LED5 fuel-gauge display.
1: Enables LED4 fuel-gauge display.
Reserved 0:2 Undefined
Figure 15. Control Register Format