Rainbow Electronics DS1726 - Manual (Page 10)

DS1626/DS1726
10 of 13
Table 5. CONFIGURATION REGISTER BIT DESCRIPTIONS
BIT NAME
(USER ACCESS)
FUNCTIONAL DESCRIPTION
DONE
(Read Only)
Power-up state = 1.
DONE = 0. Temperature conversion is in progress.
DONE = 1. Temperature conversion is complete.
THF
(Read/Write)
Power-up state = 0.
THF = 1. The measured temperature has reached or exceeded the value stored in
the T
H
register. THF will remain a 1 until it is overwritten with a 0 by the user,
the power is cycled, or a Software POR command is issued.
TLF
(Read/Write)
Power-up state = 0.
TLF = 1. The measured temperature has equaled or dropped below the value
stored in the T
L
register. TLF will remain a 1 until it is overwritten with a 0 by
the user, the power is cycled, or a Software POR command is issued.
NVB
(Read Only)
Power-up state = 0.
NVB = 1. Write to an E
2
memory cell is in progress.
NVB = 0. NV memory is not busy.
R1*
(Read/Write)
Power-up state = last value written to this bit.
Sets conversion resolution (see Table 6).
Initial state from factory = 1.
R0*
(Read/Write)
Power-up state = last value written to this bit.
Sets conversion resolution (see Table 6).
Initial state from factory = 1.
CPU*
(Read/Write)
Power-up state = last value written to this bit.
CPU = 1. Stand-alone mode is disabled.
CPU = 0. Stand-alone mode is enabled when
RST = 0. See CPU BIT AND
STAND-ALONE THERMOSTAT OPERATION section for more information.
Initial state from factory = 0.
1SHOT*
(Read/Write)
Power-up state = last value written to this bit.
1SHOT = 1: One-Shot Mode. The Start Convert T command initiates a single
temperature conversion and then the device goes into a low-power standby state.
1SHOT = 0: Continuous Conversion Mode. The Start Convert T command
initiates continuous temperature conversions.
Initial state from factory = 0.
*NV (EEPROM)
Table 6. RESOLUTION CONFIGURATION
R1 R0 RESOLUTION
CONVERSION
TIME (MAX)
0 0 9-bit 93.75ms
0 1 10-bit 187.5ms
1 0 11-bit 375ms
1 1 12-bit 750ms