TC Electronic Flashback X4 Delay - Manual (Page 24)

21
Storing presets
“So what is saved as part of a preset?”
“Every delay parameter!”
A preset includes all settings of the Flashback X4 Delay & Looper’s
delay module, including the TonePrint (i.e., if the Delay type selec-
tor is set to one of the four TonePrint slots).
If you have attached an external expression pedal to the Flashback
X4 Delay & Looper (see page 10), the parameters assigned to
this expression pedal are stored as part of the preset, too.
Storing presets
When you have selected a preset and you have changed param-
eters (e.g. the delay time), you may want to store your edited ver-
sion of the preset.
To store the current delay settings, press and hold the footswitch of
the currently active (lit) preset slot for circa two seconds.
The LEDs of the
TAP footswitch and the selected preset will blink
to confirm that the preset has been stored.
Delay spill-over
The Flashback X4 Delay & Looper has two bypass modes: True By-
pass and Buffered Bypass Changing the bypass mode is described
on page 27.
– When the Flashback X4 Delay & Looper is set to True Bypass
and you switch off the currently selected preset, the delay will
immediately be switched off.
– When the Flashback X4 Delay & Looper is set to Buffered
Bypass and you switch off the currently selected preset, the
delay will be allowed to fade/“ring out”.