TC Electronic BG250-210 - Manual (Page 15)

Operation – Front Panel
11
The two TonePrint knobs allow you to control the Tone-
Print effect amount applied to your signal. For Chorus,
Flanger, Vibrato and Octaver, the TonePrint knobs act
as
wet/dry mix controls. For Compression and Drive,
the TonePrint knobs act as amount (intensity) con-
trols. Featured TonePrint artists may have assigned
the TonePrint knob to other parameters.
Please note that while your TC bass combo can store
two separate TonePrints, only one TonePrint can be ac-
tive at any time.
Deactivating TonePrint
To switch off TonePrint, either…
■ press the button of the currently active TonePrint
section or
■ turn the knob of the currently active TonePrint slot
fully counterclockwise or
■ use a footswitch connected to the PEDAL jack – see
section 7.
5. TONEPRINT LEDs A & B
A TONEPRINT LED (A or B) lights up when the select-
ed TonePrint slot is active..
6. MASTER level knob
Use the MASTER knob to set the overall output level of
the amp. The master level also controls the level of the
PHONES output.
7. PEDAL input
You can connect a TC Electronic Switch-3 to the PED-
AL input of your bass combo to control the following
features:
■ Activate TonePrint slot A
■ Activate TonePrint slot B
■ Mute.
8. TUNER
Your bass combo’s integrated tuner allows you to easily
tune a 4, 5 or 6-string bass.