Moog Music Slim Phatty - Manual (Page 35)

Page 36
Slim Phatty User’s Manual - The User Interface
Page 37
Slim Phatty User’s Manual - The User Interface
MOD SOURCE 5 (MOD SRC 5):
This menu allows you to select one of two modulation options that
will be used when the FILT ENV source is selected on the front panel
(Modulation Source 5). FILT (Filter Envelope) is the default source, but
S-H (Sample & Hold) can be chosen as an alternate. To change the
parameter, use the CURSOR button to highlight the parameter, then
use the VALUE knob to set the new parameter value.
Values: FILT, S-H
MOD SOURCE 6 (MOD SRC 6):
This menu allows you to select one of two modulation options that
will be used when the OSC2 source is selected on the front panel
(Modulation Source 6). OSC2 (Oscillator 2) is the default source, but
Noise can be chosen as an alternate. To change the parameter, use the
CURSOR button to highlight the parameter, then use the VALUE knob
to set the new parameter value.
Values: OSC2, NOISE
MODULATION DESTINATION 2 (MOD DEST2):
This menu allows you to program a secondary destination for
modulation. The four destination options here are the same as
those offered on the front panel (the primary modulation). The
Modulation AMOUNT control specifies both the primary and
secondary modulation amounts - there is no separate amount control
for the secondary modulation. To program a secondary modulation
destination, use the CURSOR button to highlight the destination
parameter, then use the VALUE knob to set the new parameter value.
Values: OFF, PITCH, FILTER, WAVE, OSC2
PITCH BEND (PB):
The Pitch Bend menu allows you to individually set the positive and
negative ranges for MIDI Pitch Bend messages. The settings are
specified in semitones. To change either parameter, use the CURSOR
button to highlight the parameter, then use the VALUE knob to select
the new parameter value.
Values: UP: 0, +2, +3, +4, +5, +7, +12
DN: 0, -2, -3, -4, -5, -7, -12