Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1375 - Manual (Page 15)

PNEG-1375 Farm/Commercial Distributor Cable Control 15
5. INSTALLATION
Control Handle Installation
Once the upper assembly has been installed, the control handle needs to be assembled to the
lower cable wheel assembly. There are two brackets (GSB-0031) that mount to the bottom of the
lower cable wheel assembly (GSB-0049). These brackets are fastened with 5/16" x 1" bolts and
whiz nuts. The control handle (GSB-0030) is then mounted between the brackets using the
second hole in the control handle and the end hole on the brackets. This is fastened using
5/16" x 2" bolt and lock nut. The hardware required is located in (FC-DCG-HDW). This assembly
is shown in
Figure 5F .
Figure 5F