Danze D423058 - Homeowner Manual User Manual

Page 6

Hands Free Operation Trouble Shooting Guide

There is no object within the detection range but the red light is continuously on.

• After first turning the unit on it will go into programming mode automatically for a few seconds. The light will turn off automatically

after a few seconds.

• The unit is sensing a stationary object in front of the lens. This object may not be obvious to the user. The unit will reprogram itself

and the light will turn off after a few seconds.

• If the light stays on indefinitely, the electronic module may be faulty

The solenoid valve appears to be functioning incorrectly

• Check all water connections

• Check solenoid valve electronic connections

• When placing a hand in front of the sensor, check whether there is an audible “click” from the solenoid valve

• Check the filter on the solenoid valve and clean as necessary

• Change the solenoid valve

The water flow is too low

• Check to make sure that the hot/cold inlet valves are fully open

• Check the filter on the solenoid valve and clean as necessary

• Check the spout nozzle and clean as necessary

The mixed water does not have the desired temperature

• Turn the handle on the water mixer to change temperature – more towards the red or blue range if the mixed water temperature is

too cold or too hot.

• Check hot and cold water hoses for proper connection

Hands free activated water run time

• See installation instructions