Danze DC034110 - Installation Manual - Manual (Page 4)

7. Insert the floor mounting screw (J) through the
metal washer (N) and install the floor mounting
screw at the center of the L bracket slot.
8. Place the bidet (A) over the L brackets (L). If
the bidet does not slide over the L brackets (L),
remove the bidet (A) and adjust the L brackets (L)
by loosening the floor mounting screws (J) and
moving the L brackets (L) as needed. Retighten
the floor mounting screws (J) before placing bi-
det (A) over the L brackets (L).
9. Insert the bowl anchor screw (P) through the
cap washer (K). Insert the bowl anchor screw (P)
through the hole in the side of the bidet (A) and
tighten until the bidet (A) is secure.
10. Push caps (O) over the cap washers (K) to
conceal the heads of the bowl anchor screws
(P).
11. Complete the faucet and drain connections
per the manufacturer’s recommendations.
Please refer to Homeowner Care Manual for care and maintenance information.
InstallatIon InstructIons
1. Assemble the bidet faucet and drain (not in-
cluded) according to the manufacturer’s recom-
mendations.
2. Set bidet (A) into place on the floor.
3. Trace outline of bidet base and the mark the
location of the floor anchoring holes.
4. Set the bidet (A) aside while installing the L
brackets (L).
5. Measure in ½" from the point where the
outline of the bidet (A) and the location of the
anchoring holes cross. Place the front of the L
bracket (L) in that location and mark the center
of the L bracket slot.
6. Floor expansion anchors (M) are included for
installation in concrete slab or tile surfaces. For
installations using the floor expansion anchors
(M), drill two
5 / 16 " diameter holes at the marks
indicating the center of the L bracket slots. For
installations without the floor expansion anchor
(M), drill two
3 /
16
" diameter holes at the marks
indicating the center of the L bracket slots.