Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Tuner- Six-Gun Diesel Tuner '07-10 (iQ) Compatible with Optional Banks iQ - Manual (Page 16)

16
96819 v.3.0
Remove the fuse access panel shown
in Figure 7. Remove the lower knee
bolster panel by removing the 2
Phillips screws on the lower edge
of the panel. Using a 10mm socket
and ratchet, unbolt the brake release
lever. Pull the panel out by grasping it
on either side of the steering column
and pull out as shown in Figure 16.
Disconnect any switch wires.
5.
cut out th e supplied template,
Figure 25, and align the template
to the right e dge of the IP to the left
of the steering column. Tape the
template in place. A 90° drill will be
needed to drill the hole. continue to
Step 7.
6.
To install Switch as shown in
Figures 12 & 13:
Follow Step 4 to remove the IP for
both Dash styles. C ut out the supplied
template, Figure 26, a nd align the
template onto the rear of the knee
bolster, squarely seating it into the
panel corner as shown in Figure 17.
7.
Using a 3 ⁄
8
” Uni-bit step drill bit or
a 3 ⁄
8
” drill bit, center the bit onto the
3 ⁄
8
” drill location on the template and
slowly drill through the IP. Using a 1 ⁄
8
”
drill bit, center and drill through the
1 ⁄
8
” location on the template. Remove
and discard the template and any
plastic shavings.
8.
On the front side of where the
Switch will be mounted, clean the area
with some alcohol and allow it to dry.
Remove the backing from the Six-Gun
Label and align it over the previously
drilled hole.
9.
Remove the nut and internal tooth
washer from the Six-Gun Switch.
Rotate the shaft counter clockwise
until the shaft stops. Verify the locating
washer tab is inserted into the #6
position on the Switch (Figure 18).
Figure 16