Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Speed Control- Banks Brake w_ Switch - Manual (Page 16)

16
97247 v.3.0
of the panel. Using a 10mm socket
and ratchet, unbolt the brake release
lever. Pull the panel out by grasping it
on either side of the steering column
and pull out as shown in Figure 17.
Disconnect any switch wires.
5.
Cut out the supplied template,
Figure 21 on page 23, and align the
template to the right edge of the IP to
the left of the steering column. Tape
the template in place. A 90° drill will
be needed to drill the hole. continue
to Step 7.
6.
To install Switch as shown in
Figures 13 & 14:
Follow Step 4 to remove the IP for
both Dash styles. Cut out the supplied
template, Figure 22 on page 23, and
align the template onto the rear of the
knee bolster, squarely seating it into
the panel corner as shown in Figure
18.
7.
Using a 3 ⁄
8
” Uni-bit step drill bit or
a 3 ⁄
8
” drill bit, center the bit onto the
3 ⁄
8
” drill location on the template and
slowly drill through the IP. Using a 1 ⁄
8
”
drill bit, center and drill through the
1 ⁄
8
” location on the template. Remove
and discard the template and any
plastic shavings.
8.
On the front side of where the
Switch will be mounted, clean the
area with some alcohol and allow it
to dry. Remove the backing from the
Banks Brake Label and align it over the
previously drilled hole.
9.
Remove the nut and internal tooth
washer from the Banks Brake Switch.
Rotate the shaft counter clockwise
until the shaft stops. Verify the locating
washer tab is inserted into the #5
position on the Switch (Figure 19).
NOTE: If the washer is in any position
other then the #5, your Banks Brake
will not select power levels properly.
Figure 12 Figure 13